Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Instrument Panel Outer Air Outlet Replacement - Left Side

Chevrolet Cruze Repair Manual / HVAC System / Instrument Panel Outer Air Outlet Replacement - Left Side

Preliminary Procedure

Preliminary Procedure

  1. Remove instrument panel lower trim pad cover - left side. Refer to Instrument Panel Lower Trim  Pad Cover Replacement.
  2. Remove instrument panel cluster trim plate. Refer to Instrument Panel Cluster Trim Plate Replacement.
  3. Remove instrument panel cluster lower trim plate. Refer to Instrument Panel Cluster Lower Trim Plate Replacement.
  4. Remove instrument panel upper trim panel. Refer to Instrument Panel Upper Trim Panel Replacement - Left Side.
  1. Instrument Panel Outer Air Outlet Assembly

Procedure

  1. Remove instrument panel outer air oulet duct left side.
  2. Remove clip (Qty: 4).

Instrument Panel Center Air Outlet Replacement

Preliminary Procedure

Preliminary Procedure

Remove instrument panel center upper molding (2). Refer to Instrument Panel Center Upper Molding Replacement.

  1. Instrument Panel Center Air Outlet

Instrument Panel Outer Air Outlet Replacement - Right Side

Preliminary Procedure

Preliminary Procedure

Remove instrument panel upper trim panel. Refer to Instrument Panel Upper Trim Panel Replacement - Right Side.

Instrument Panel Outer Air Outlet Assembly

Procedure

  1. Remove instrument panel outer  air oulet duct right side.
  2. Remove clip (Qty: 4).

Radio Cooling Duct Replacement (Right Hand Drive)

Preliminary Procedure

Preliminary Procedure

  1. Remove IP Compartment. Refer to Instrument   Panel Compartment Replacement.
  2. Remove floor air outlet duct - left side. Refer to Floor Air Outlet Duct Replacement - Left Side.

Radio Cooling Duct

Procedure

Remove radio cooling duct.

Air Conditioning Condenser Replacement (1.6L LDE, LXT, LXV, and 1.8L 2H0)
Removal Procedure Recover the refrigerant. Refer to Refrigerant Recovery and Recharging. Disconnect battery negative cable. Refer to Battery Negative Cable Disconnection and Connection. Rem ...

Floor Air Outlet Replacement
Removal Procedure Remove the instrument panel assembly. Refer to Instrument Panel  Assembly Replacement. Remove the instrument panel wiring harness (2) from the instrument panel ...

Other materials:

Deployment Inside Vehicle - Vehicle Scrapping Procedure
Deploy the inflator modules inside of the vehicle when destroying the vehicle or when salvaging the vehicle for parts. This includes, but is not limited to, the following situations: The vehicle has completed all useful life. Irreparable damage occurred to the vehicle in a non-deployment ty ...

Front Fender Emblem/Nameplate Replacement (1.8L 2H0 or 2.0L Diesel)
Front Fender Emblem Assembly Caution: Refer to Exterior Trim Emblem Removal Caution in the Preface section. Procedure The part and surface should be 21°C (70°F) prior to installation. The vehicle should remain 21°C (70°F) for one hour after assembly to allow adhesive to develop suff ...

Drive Belt Replacement
Special Tools EN 6349 Locking Pin For equivalent regional tools, refer to Special Tools. Removal Procedure Open the hood. Remove the power steering pump belt. Refer to Power Steering Pump Belt Replacement. Raise the vehicle by its full height. Refer to Lifting and Jacking the Vehicl ...

© 2017-2021 Copyright www.crion.site