Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Installation Procedure

  1. Install the following components on the drivetrain and front suspension frame:

Note: Check marking of frame insulator.

  1. Press carefully the frame insulator in to the front suspension frame, using CH 6616 hand pump .
  2. Remove the following components from the drivetrain and front suspension frame:
  1. Install the drivetrain and front suspension frame. Refer to Drivetrain and Front Suspension Frame Replacement.

Front Wheelhouse Liner Replacement

Preliminary Procedure

Preliminary Procedure

Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation.

  1. Front Wheelhouse Liner Screw (Qty: 5)

Caution: Refer to Fastener Caution in the Preface section.

Tighten 2.5 N·m (23 lb in)

  1. Front Wheelhouse Liner Plastic Retainer (Qty: 7)
  2. Front Wheelhouse Liner

Rear Wheelhouse Panel Liner Replacement

Preliminary Procedure

Preliminary Procedure

Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation.

  1. Rear Wheelhouse Panel Liner Screw (Qty: 4)

Caution: Refer to Fastener Caution in the Preface section.

Tighten 2.5 N·m (23 lb in)

  1. Rear Wheelhouse Panel Liner Nut (Qty: 2)

Tighten 2.5 N·m (23 lb in)

  1. Rear Wheelhouse Panel Liner Plastic Retainer (Qty: 2)
  2. Rear Wheelhouse Panel Liner

Front Fog Lamp Bezel Replacement

Preliminary Procedure

Preliminary Procedure

  1. Remove front bumper fascia. Refer to Front Bumper Fascia Replacement.
  2. Remove front fog lamp. Refer to Front Fog Lamp Replacement.

Front Fog Lamp Bezel Screw

Caution: Refer to Fastener Caution in the Preface section.

Tighten 2.5 N·m (23 lb in)

Front Fog Lamp Bezel

Procedure

  1. Disengage the 4 inner retainer tabs securing the bezel to the front bumper fascia.
  2. Pull outward from the outer edge in order to release the outer retention clips securing the bezel to the front bumper fascia.
  3. Remove the front fog lamp bezel.

Special Tools and Equipment

Paint and Coatings

Removal Procedure
Remove the drivetrain and front suspension frame. Refer to Drivetrain and Front   Suspension Frame Replacement. Mark Installation position of insulator (2) at frame (1). ...

Paint and Coatings
...

Other materials:

Pretensioner Handling and Scrapping
Special Tools EL-38826 SIR Deployment Harness EL-39401-B SIR Deployment Fixture For equivalent regional tools, refer to Special Tools. Warning: When you are carrying an undeployed seat belt pretensioner: Do not carry the seat belt pretensioner by the wires or connector on the preten ...

Horns
Specifications Horn Replacement Preliminary Procedure Remove the front bumper fascia. Refer to Front Bumper Fascia Replacement. Horn Nut Caution: Refer to Fastener Caution in the Preface section. Tighten 17 N·m (13 lb ft) Horn Tip Disconnect electrical connectors. St ...

Wheel Alignment Measurement
Steering and vibration complaints are not always the result of improper alignment. One possible cause is wheel and tire imbalance. Another possibility is tire lead due to worn or improperly manufactured tires. Lead/pull is defined as follows: At a constant highway speed on a typical straight ...

© 2017-2021 Copyright www.crion.site