Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Installation Procedure

Note: If the location of the original plug weld holes can not be

Note: If the location of the original plug weld holes can not be determined, space the braze holes every 40 mm (1½ in).

  1. Create 5 x 18 mm (4/16 x 11/16 in) slots for MIG-brazing along the edges of the rear floor panel filler as noted from the original panel.
  2. Clean and prepare the attaching  surfaces for welding.

  1. Position the rear floor panel filler on the vehicle.
  2. Verify the fit of the rear floor panel filler.
  3. Clamp the rear floor panel filler into position.

  1. Braze accordingly.
  2. Apply the sealers and anti-corrosion materials to the repair area, as necessary. Refer to Anti-Corrosion Treatment and Repair.
  3. Paint the repaired area. Refer to Basecoat/Clearcoat Paint Systems
  4. Install all related panels and components.
  5. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection.
  6. Enable the SIR system. Refer to SIR Disabling and Enabling.
Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section. Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section. Disable the SIR Syst ...

Tail Lamp Pocket Replacement (MAG-Welding)
Note: According to different corrosion warranties, only the regional mandatory joining methods are allowed. ...

Other materials:

Heating and Air Conditioning System Description and Operation
Engine Coolant Engine coolant is the key element of the heating system. The thermostat controls engine operating coolant temperature. The thermostat also creates a restriction for the cooling system that promotes a positive coolant flow and helps prevent cavitation. Coolant enters the heater ...

Pictures
Pictures can only be viewed using USB devices. If pictures are on an SD card, transfer to a USB device or use a USB-SD adapter. File sizes above approximately four mega pixels may not show. Only jpeg, bmp, gif, and png files are supported. 1. Press the Pictures screen button on the Home Page. ...

Front Side Door Upper Hinge and Lower Hinge Replacement
Preliminary Procedure Remove the front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement. Remove the front fender insulator. Refer to Front Fender Insulator Replacement. Remove the front side door. Refer to Front Side Door Replacement. Front Side Door Hinge Bolt ( ...

© 2017-2021 Copyright www.crion.site