Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Installation Procedure

  1. Create 8 24 mm (5/16 x 15/16 in) slots for MIG-brazing along the edges of the underbody rear side rail reinforcement as noted from the original panel.
  2. Clean and prepare the attaching  surfaces for brazing.

  1. Position the underbody rear side rail reinforcement on the vehicle.
  2. Verify the fit of the underbody rear side rail reinforcement.
  3. Clamp the underbody rear side rail reinforcement into position.

  1. Braze accordingly.
  2. Apply the sealers and anti-corrosion materials to the repair area, as necessary. Refer to Anti-Corrosion Treatment and Repair.
  3. Paint the repaired area. Refer to Basecoat/Clearcoat Paint Systems.
  4. Install all related panels and components.
  5. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection.
  6. Enable the SIR system. Refer to SIR Disabling and Enabling.
Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section. Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section. Disable the SIR Syst ...

Rear Floor Panel Filler Replacement (MAG-Welding)
Note: According to different corrosion warranties, only the regional mandatory joining methods are allowed. ...

Other materials:

Object Detection System Messages
PARK ASSIST OFF This message displays when the park assist system has been turned off or when there is a temporary condition causing the system to be disabled. SERVICE PARK ASSIST This message displays if there is a problem with the Ultrasonic Rear Parking Assist (URPA) system. Do not use thi ...

Installation Procedure
Position the lower control arm (1) in the cradle. Install and hand tighten the NEW rear lower control arm bushing nuts and bolts (1). Install and hand tighten the NEW front lower control arm nut and bolt (1). Caution: Refer to Fastener Caution in the Preface secti ...

Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section. Warning: Refer to Collision Sectioning Warning in the Preface section. Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section. Disable the SIR System. Refer to SIR  Dis ...

© 2017-2021 Copyright www.crion.site