Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Installation Procedure

  1. Clean and prepare the attaching surfaces for welding.
  2. Apply structural adhesive to the attaching flanges.

  1. Position the body side outer lower panel on the vehicle
  2. Verify the fit of the body side outer lower panel.
  3. Clamp the body side outer lower panel into position.

  1. Spot weld accordingly.
  2. Apply the sealers and anti-corrosion materials to the repair area, as necessary. Refer to Anti-Corrosion Treatment and Repair.
  3. Paint the repaired area. Refer to Basecoat/Clearcoat Paint Systems.
  4. Install all related panels and components.
  5. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection.
  6. Enable the SIR system. Refer to SIR Disabling and Enabling.
Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section. Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section. Disable the SIR Syst ...

Rear Compartment Floor Panel Sectioning (MAG-Welding)
Note: According to different corrosion warranties, only the regional mandatory joining methods are allowed. ...

Other materials:

Installation Procedure
Drill 8 mm (5/16 in) for plug welding along the edges of the service panel as noted    from the original panel. Clean and prepare the attaching surfaces for welding. Position the body lock pillar inner panel on the vehicle. Verify the fit of the panel. Clamp th ...

Navigation Symbols
Following are the most common symbols that appear on a map screen. The vehicle symbol indicates the current position and heading direction of the vehicle on the map. The destination symbol marks the final destination after a route has been planned. The waypoint symbol marks one or more se ...

Installation Procedure
Prepare all mating surfaces as necessary. Align the front hinge pillar body reinforcement. Drill 8 mm (5/16 in) for plug welding along the edges of the front hinge pillar body as noted   from the original panel. Clean and prepare the attaching surfaces for welding. ...

© 2017-2021 Copyright www.crion.site