Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Installation Procedure

  1. Cut the front compartment front rail in corresponding locations to fit the remaining original panel. The sectioning joint should be trimmed to allow a gap of one-and-one-half-times the metal thickness at the sectioning joint.
  2. Create a 50 mm (2 in) backing plate from the unused portion of the service part  and use where possible.
  3. Create 5 x 18 mm (4/16 x 11/16 in) slots for MIG-brazing along the sectioning cut on the remaining original part. Locate these holes 13 mm (1/2 in) from the edge of part and spaced 40 mm (1 1/2 in) apart.
  4. Prepare all mating surfaces as necessary.
  5. Fit the backing plates halfway into the sectioning joints, clamp in place and braze to the vehicle.
  6. Align the front compartment front rail.
  7. Clean and prepare the attaching surfaces for brazing.

  1. Position the front compartment front rail on the vehicle.
  2. Verify the fit of the front compartment front rail.
  3. Clamp the front compartment front rail into position.

  1. Braze accordingly.
  2. To create a solid braze with minimum heat distortion, make 25 mm (1 in) stitch brazes along the seam with 25 mm (1 in) gaps between them. Then go back and complete the stitch braze.
  3. Apply the sealers and anti-corrosion materials to the repair area, as necessary. Refer to Anti-Corrosion Treatment and Repair.
  4. Paint the repaired area. Refer to Basecoat/Clearcoat Paint Systems.
  5. Install all related panels and components.
  6. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection.
  7. Enable the SIR system. Refer to SIR Disabling and Enabling.
Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section. Warning: Refer to Collision Sectioning Warning in the Preface section. Warning: Refer to Glass and She ...

Front Compartment Side Rail Sectioning (Short, MAG-Welding)
Note: According to different corrosion warranties, only the regional mandatory joining methods are allowed. ...

Other materials:

Power Steering System Description and Operation
The hydraulic power steering pump is a constant displacement vane-type pump that provides hydraulic pressure and flow for the power steering gear. The hydraulic power steering pumps are either belt-driven or direct-drive, cam-driven. The power steering fluid reservoir holds the power steerin ...

Steering Wheel and Column Description and Operation
The steering wheel and column has 4 primary functions: Vehicle steering Vehicle security Driver convenience Driver safety Vehicle Steering The steering wheel is the first link between the driver and the vehicle. The steering wheel is fastened to a steering shaft within the column. A ...

Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section. Warning: Refer to Collision Sectioning Warning in the Preface section. Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section. Disable the SIR System. Refer to SIR &nbs ...

© 2017-2021 Copyright www.crion.site