Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Installation Procedure

  1. Remove the front wheelhouse rear panel brace (1) from service panel.

  1. Drill 8 mm (5/16 in) for plug welding instead of the adhesive noted from the front area of the original panel.

Note: Double the number of drills at the flange where front

Note: Double the number of drills at the flange where front wheelhouse panel and front compartment side rail overlap (1).

  1. Drill 8 mm (5/16 in) for plug welding along the edges of the front wheelhouse as noted from the original panel.
  2. Clean and prepare the attaching surfaces for welding.

  1. Position the front wheelhouse on the vehicle.
  2. Verify the fit of the front wheelhouse.
  3. Clamp the front wheelhouse into position.

  1. Plug weld accordingly.
  2. Apply the sealers and anti-corrosion materials to the repair area, as necessary. Refer to Anti-Corrosion Treatment and Repair.
  3. Paint the repaired area. Refer to Basecoat/Clearcoat Paint Systems.
  4. Install all related panels and components.
  5. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection.
  6. Enable the SIR system. Refer to SIR Disabling and Enabling.
Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section. Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section. Disable the SIR Syst ...

Front Wheelhouse Panel Replacement (MIG-Brazing)
Note: According to different corrosion warranties, only the regional mandatory joining methods are allowed. ...

Other materials:

Emergency
With Automatic Crash Response, the built-in system can automatically connect to help in most crashes, even if help cannot be requested. Press to connect to an Emergency Advisor. GPS technology is used to identify the vehicle location and can provide critical information to emergency personne ...

Rear Bumper Fascia Guide Replacement
Preliminary Procedure Remove the rear bumper fascia. Refer to Rear Bumper Fascia Replacement. Rear Bumper Fascia Guide Rivet (Qty: 4) Special Tools BO-594-A Hand Rivet Tongs For equivalent regional tools, refer to Special Tools. Rear Bumper Fascia Guide Rear Bumper Fascia Inner ...

Ultrasonic Parking Assist
The Ultrasonic Rear Parking Assist (URPA) system assists the driver with parking and avoiding objects while in R (Reverse). URPA operates at speeds less than 8 km/h (5 mph). The sensors on the rear bumper detect objects up to 2.5m (8 ft) behind the vehicle, and at least 20 cm (8 in) off the gr ...

© 2017-2021 Copyright www.crion.site