Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Installation Procedure

  1. Position the front end upper tie bar (1) on the vehicle.
  2. Verify the fit of the front end upper tie bar.
  3. Clamp the front end upper tie bar into position.

  1. Weld seam accordingly.

  1. Weld seam accordingly.
  2. Grind down weld seams as needed for related panels and components.

  1. Drill 8 mm (5/16 in) for plug welding along the edges of the service panel as noted from the original panel.
  2. Clean and prepare the attaching surfaces for welding.

  1. Position the front end sheet metal cross panel reinforcement (1) on the vehicle.
  2. Verify the fit of the front end upper tie bar.
  3. Clamp the front end sheet metal cross panel reinforcement into position.

  1. Plug weld accordingly.
  2. Install front bumper impact bar before applying the sealers and anti-corrosion materials.
  3. Apply the sealers and anti-corrosion materials to the repair area, as necessary. Refer to Anti-Corrosion Treatment and Repair
  4. Paint the repaired area. Refer to Basecoat/Clearcoat Paint Systems
  5. Install all related panels and components
  6. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection
  7. Enable the SIR system. Refer to SIR Disabling and Enabling
Removal Procedure
Disable the SIR System. Refer to SIR Disabling and Enabling. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection. Remove all related panels an ...

Front End Upper Tie Bar Replacement (MIG-Brazing)
Note: According to different corrosion warranties, only the regional mandatory joining methods are allowed. ...

Other materials:

Tyre and Wheel Removal and Installation
Removal Procedure Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle. Remove the wheel center cap. Mark the relationship of the wheel (2) to the hub. Remove the wheel nuts (1). Warning: If penetrating oil gets on the vertical surfaces between the ...

Steering Wheel Inflatable Restraint Module Replacement
Removal Procedure Warning: When carrying a live inflator module, make sure the bag opening is pointed away from you. This minimizes the chance of injury in the case of an accidental deployment. Never carry the inflator module by the wires. Never carry the inflator module by the connector on t ...

Installation Procedure
Cut the front compartment front rail in corresponding locations to fit the remaining original panel. The sectioning joint should be trimmed to allow a gap of one-and-one-half-times the metal thickness at the sectioning joint. Create a 50 mm (2 in) backing plate from the unused porti ...

© 2017-2021 Copyright www.crion.site