Chevrolet Cruze Repair Manual: Hood Primary Latch Release Cable Replacement
Preliminary Procedure
- Remove hood primary latch release cable handle. Refer to Hood Primary Latch Release Cable Handle Replacement.
- Remove the front bumper fascia. Refer to Front Bumper Fascia Replacement
- Remove the radiator grille support. Refer to Radiator Grille Reinforcement Support Replacement.
- Remove the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement.
Hood Primary Latch Release Cable
Procedure
To release the hood primary latch release cable, unhook from hood primary and secondary latch.
Front Fender Front Lower Bracket Replacement
Preliminary Procedure
Remove the front bumper fascia. Refer to Front Bumper Fascia
Replacement.
Remove the headlamp. Refer to Headlamp Replacement
Remove the front fender. R ...
Rear Side Door Check Replacement
Preliminary Procedure
Remove rear side door trim panel. Refer to Rear Side Door
Trim Replacement
Remove the rear side door water deflector. Refer to Rear Side Door Water
De ...
Other materials:
Rear Compartment Lid Emblem/Nameplate Replacement (VCDi)
Rear Compartment Lid Emblem Assembly
Caution: Refer to Exterior Trim Emblem Removal Caution in the
Preface section.
Procedure
The part and surface should be 21°C (70°F) prior to installation. The
vehicle should remain 21°C (70°F) for
one hour after assembly to allow adhesive to deve ...
Relieving Fuel Pressure Warning
Warning: Remove the fuel tank cap and relieve the fuel system
pressure before servicing the fuel system in order to reduce the risk of
personal injury. After you relieve the fuel system pressure, a small amount of
fuel may be released when servicing the fuel lines, the fuel
injection pump, or ...
Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in the
Preface section.
Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section.
Disable the SIR System. Refer to SIR Disabling and Enabling.
Disconnect the negative battery cable. Refer to Battery N ...