Chevrolet Cruze Repair Manual: Hood Primary and Secondary Latch Replacement
Preliminary Procedure
- Remove the front bumper fascia. Refer to Front Bumper Fascia Replacement.
- Remove the radiator grille support reinforcement. Refer to Radiator Grille Reinforcement Support Replacement.
- Hood Primary and Secondary Latch Retainer Bolt (Qty: 2)
Caution: Refer to Fastener Caution in the Preface section.
Tighten 20 N·m (15 lb ft).
- Hood Primary and Secondary Latch
Procedure
- To release the hood primary and secondary latch unhook the hood primary latch release cable.
- Disconnect electrical connectors as needed.
Hood Replacement
Warning: When a hood hold open device is being removed or installed,
provide alternate support to avoid the possibility of
damage to the vehicle or personal injury.
Preliminary Procedure
Remo ...
Rear Compartment Lid Adjustment
Rear Compartment Lid
Caution: Refer to Fastener Caution in the Preface section.
Procedure
Loosen the rear compartment lid hinge bolt (Qty: 4) to
adjust the rear compartment li ...
Other materials:
Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in the
Preface section.
Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section.
Disable the SIR System. Refer to SIR Disabling and Enabling.
Disconnect the negative battery cable. Refer to Batt ...
Windshield Garnish Molding Replacement
Preliminary Procedure
Disable the SIR system. Refer to SIR Disabling and Enabling.
Windshield Garnish Molding Assembly
Procedure
Loosen tether clip and steel clips.
Disconnect electrical connector.
The tether clip at the upper portion of the garnish molding MUST be
repla ...
Securing Child Restraints (Rear Seat)
When securing a child restraint in a rear seating position, study the instructions
that came with the child restraint to make sure it is compatible with this vehicle.
If the child restraint has the LATCH system.
Do not secure a child seat in a position without a top tether anchor if a national
...