Chevrolet Cruze manuals

Chevrolet Cruze Owners Manual: Hood

To open the hood:

1. Pull up on the hood release handle. It is located inside the vehicle to the

1. Pull up on the hood release handle. It is located inside the vehicle to the left of the steering column.

2. Go to the front of the vehicle and push the secondary hood release handle

2. Go to the front of the vehicle and push the secondary hood release handle toward the driver side of the vehicle.

3. Lift the hood and release the hood prop from its retainer, located above the

3. Lift the hood and release the hood prop from its retainer, located above the radiator.

Securely place the hood prop into the slot on the underside of the hood.

To close the hood:
1. Before closing the hood, be sure all the filler caps are on properly.

Then, lift the hood to relieve pressure on the hood prop.

Remove the hood prop from the slot on the underside of the hood and return the prop to its retainer. The prop rod must click into place when returning it to the retainer to prevent hood damage.

2. Lower the hood 30 cm (12 in) above the vehicle and release it so it fully latches. Check to make sure the hood is closed and repeat the process if necessary.

Doing Your Own Service Work
WARNING It can be dangerous to work on your vehicle if you do not have the proper knowledge, service manual, tools, or parts. Always follow owner manual procedures and consult the service manual ...

Engine Compartment Overview
1.4L L4 Engine   1. Engine Air Cleaner/Filter 2. Engine Oil Dipstick. 3. Engine Cooling Fan (Out of View). 4. Engine Oil Fill Cap. 5. Remote Negative (-) Grounding Point. 6. Brake/Clutch ...

Other materials:

Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section. Warning: Refer to Collision Sectioning Warning in the Preface section. Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section. Disable the SIR System. Refer to SIR &nbs ...

Forward Lamp Wiring Harness Replacement
Preliminary Procedures Remove the front bumper. Refer to Front Bumper Fascia Replacement. Remove the headlamp. Refer to Headlamp Replacement. Using a scan tool, check for DTCs. Forward Lamp Wiring Harness Tip Create a work area large enough to lay out the new and old wiring ha ...

Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section. Warning: Refer to Collision Sectioning Warning in the Preface section. Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section. Disable the SIR System. Refer to SIR  Dis ...

© 2017-2021 Copyright www.crion.site