Chevrolet Cruze manuals

Chevrolet Cruze Owners Manual: Heated Front Seats

WARNING

If you cannot feel temperature change or pain to the skin, the seat heater may cause burns. To reduce the risk of burns, people with such a condition should use care when using the seat heater, especially for long periods of time. Do not place anything on the seat that insulates against heat, such as a blanket, cushion, cover, or similar item. This may cause the seat heater to overheat. An overheated seat heater may cause a burn or may damage the seat

If available, the controls are on the center stack. The engine must be running

If available, the controls are on the center stack. The engine must be running to operate the heated seats.

Press to heat the driver or passenger seat or cushion and seatback. to heat the driver or passenger seat cushion and seatback.

Press the control once for the highest setting. With each press of the control, the heated seat will change to the next lower setting, and then the off setting. Three lights indicate the highest setting and one light the lowest.

The passenger seat may take longer to heat up.

Remote Start Heated Seats

When it is cold outside, the heated seats can be turned on automatically during a remote vehicle start. The heated seats will be canceled when the ignition is turned on. Press the control to use the heated seats after the vehicle is started.

The heated seat indicator lights on the control do not turn on during a remote start.

The temperature performance of an unoccupied seat may be reduced.

This is normal.

The heated seats will not turn on during a remote start unless the heated seat feature is enabled in the vehicle personalization menu.

Reclining Seatbacks
WARNING If either seatback is not locked, it could move forward in a sudden stop or crash. That could cause injury to the person sitting there. Always push and pull on the seatbacks to be sure the ...

Rear Seats
Either side of the rear seatback can be folded. To fold the rear seatbacks: 1. Place the front seatbacks in the upright position. Notice: Folding a rear seat with the safety belts still fastened ma ...

Other materials:

Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section. Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section. Disable the SIR System. Refer to SIR  Disabling and Enabling. Disconnect the negative battery cable. Refer to ...

Installation Procedure
Cut the front hinge pillar body in corresponding locations to fit the remaining original panel. The sectioning joint should be trimmed to allow a gap of one-and-one-half-times the metal thickness at the sectioning joint. Create a 50 mm (2 in) backing plate from the unused portion of ...

Inflatable Restraint Module Handling and Scrapping
Special Tools EL-38826 SIR Deployment Harness EL-39401-B SIR Deployment Fixture For equivalent regional tools, refer to Special Tools. Live and Undeployed Inflator Module Warning: Refer to SIR Inflator Module Handling and Storage Warning in the Preface section. Take special care when h ...

© 2017-2021 Copyright www.crion.site