Chevrolet Cruze manuals

Chevrolet Cruze Owners Manual: Headlamps, Front Turn Signal and Parking Lamps

Chevrolet Cruze Owners Manual / Vehicle Care / Bulb Replacement / Headlamps, Front Turn Signal and Parking Lamps

1. Parking/Turn Signal Lamp

1. Parking/Turn Signal Lamp 2. High-Beam Headlamp/ Low-Beam Headlamp and DRL

High-Beam Headlamp/ Low-Beam Headlamp and DRL

1. Open the hood
2. For the driver side bulb, remove the windshield washer bottle filler neck by firmly pulling it straight up and out of the bottle.

3. Remove the connector retaining tab (1).

3. Remove the connector retaining tab (1).

4. Disconnect the wiring harness connector from the bulb (3) by pressing the connector release (2) and pulling straight back.

5. Remove the bulb (3) from the headlamp assembly by turning counterclockwise and pulling straight back.

6. Install the new bulb in the headlamp assembly by turning clockwise.

7. Install the wiring harness connector to the bulb. Be sure the connector release (2) locks into place.

8. Install the connector retaining tab (1).

9. For the driver side, reinstall the windshield washer bottle filler neck by firmly pushing it straight into the bottle. Ensure that the filler neck clip engages into the underhood electrical center retainer.

Parking/Turn Signal Lamp

1. Open the hood.

2. For the driver side bulb, remove the windshield washer bottle filler neck by firmly pulling it straight up and out of the bottle.

3. Remove the parking/turn signal lamp bulb socket from the headlamp assembly

3. Remove the parking/turn signal lamp bulb socket from the headlamp assembly by turning counterclockwise.

4. Remove the bulb from the bulb socket.

4. Remove the bulb from the bulb socket.

5. Install the new bulb in the bulb socket.

6. Install the bulb socket into the headlamp assembly by turning clockwise.

7. For the driver side, reinstall the windshield washer bottle filler neck by firmly pushing it straight into the bottle. Ensure that the filler neck clip engages into the underhood electrical center retainer.

Halogen Headlamps
WARNING Halogen bulbs have pressurized gas inside and can burst if you drop or scratch the bulb. You or others could be injured. Be sure to read and follow the instructions on the bulb package. ...

Taillamps, Turn Signal, Sidemarker, Stoplamps, and Back-Up Lamps
Trunk Deck Inboard Taillamps 1. Open the trunk. 2. Remove the trunk deck trim cover (1). 3. Remove the bulb socket (2) by turning counterclockwise and pulling straight out. 4. Remove the bul ...

Other materials:

Engine Exhaust
WARNING Engine exhaust contains carbon monoxide (CO) which cannot be seen or smelled. Exposure to CO can cause unconsciousness and even death. Exhaust may enter the vehicle if: • The vehicle idles in areas with poor ventilation (parking garages, tunnels, deep snow that may block underbody air ...

Navigation Symbols
Following are the most common symbols that appear on a map screen. The vehicle symbol indicates the current position and heading direction of the vehicle on the map. The destination symbol marks the final destination after a route has been planned. The waypoint symbol marks one or more se ...

Wheel Replacement
Replace any wheel that is bent, cracked, or badly rusted or corroded. If wheel nuts keep coming loose, the wheel, wheel bolts, and wheel nuts should be replaced. If the wheel leaks air, replace it. Some aluminum wheels can be repaired. See your dealer if any of these conditions exist. Your de ...

© 2017-2021 Copyright www.crion.site