Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Headlamp Aiming Procedure

  1. Open the hood. Measure from the floor to the center of the headlamp bulb. Some
  2. Measure from the floor to the center of the headlamp bulb. Some headlamps have an aim dot marked on the headlamp lens.
  3. At the screen, measure from the floor and place the horizontal tape at the measured distance.
  4. Measure from the reference line on the floor to the left headlamp bulb centerline.
  5. At the screen, measure from the reference line and place the vertical tape at the measured distance.
  6. Measure from the reference line on the floor to the right headlamp bulb centerline.
  7. At the screen, measure from the reference line and place the vertical tape at the measured distance.

Important: DO NOT cover the headlamp. This may cause excessive heat build up.

  1. Turn ON the low beam headlamps. Block the light from projecting onto the screen from the passenger side headlamp.

Important: The headlamps can not be adjusted horizontally.

Important: The headlamps can not be adjusted horizontally.

  1. Adjust the vertical aim screw of the headlamps to the specifications required by the state and the local authorities, or as shown in step number 8.
  2. Repeat the aiming procedure for the passenger side headlamp while blocking the light from projecting onto the screen from the driver side headlamp.
  3. Turn the headlamps OFF.
  4. Close the hood.
Visual Aiming Preparation Procedure
Important: Some state and local laws specify requirements for headlamp aim. Comply with all of these laws when performing any headlamp aiming operations. Headlamp aim should be checked: When a ...

Front Fog Lamp Replacement
Preliminary Procedures Raise and support the vehicle. Refer to Lifting   and Jacking the Vehicle. Remove the front bumper fascia. Refer to Front Bumper Fascia Replacement. Disco ...

Other materials:

Hood Hold-Open Rod Replacement
Warning: Refer to Hood Hold-Open Device Warning in the Preface section. Preliminary Procedure Remove the radiator grille reinforcement support. Refer to Radiator Grille Reinforcement Support Replacement. Hood Hold Open Rod Pivot (Qty: 2) Hood Hold Open Rod ...

Center Pillar Upper Garnish Molding Replacement
Preliminary Procedure Remove the center pillar lower garnish molding. Refer to Center Pillar Lower Ga   rnish Molding Replacement Remove the seat belt from the front seat. Refer to Driver or Passenger Seat Retractor Side Belt Replacement Center Pillar Upper Garnish Mo ...

Installation Procedure
Drill 8 mm (5/16 in) for plug welding along the edges of the rear bumper impact bar stud plate as noted from the original panel. Note: If the location of the original plug weld holes can not be determined, space the plug weld holes every 40 mm (1½ in). Clean and prepare the ...

© 2017-2021 Copyright www.crion.site