The vehicle's front and rear seats have adjustable head restraints in the outboard seating positions.
With head restraints that are not installed and adjusted properly, there is a greater chance that occupants will suffer a neck/ spinal injury in a crash. Do not drive until the head restraints for all occupants are installed and adjusted properly.
Adjust the head restraint so that the top of the restraint is at the same height as the top of the occupant's head. This position reduces the chance of a neck injury in a crash.
The height of the head restraint can be adjusted. Pull the head restraint up to raise it. Try to move the head restraint to make sure that it is locked in place.
To lower the head restraint, press the button, located on the top of the seatback, and push the head restraint down. Try to move the head restraint after the button is released to make sure that it is locked in place.
The front seat outboard head restraints are not designed to be removed.
This information provides repair recommendations and general guidelines for steel classified as Mild Steel. This type of steel normally has a tensile strength less than 270 MPa. This includes the common steel names of: Mild Steel Bake Hardenable Steel (BH) Solid Solution Strengthened Stee ...
Remote Vehicle Start
The vehicle may have this feature that allows you to start the engine from outside the vehicle. (Remote Vehicle Start): This button will be on the RKE transmitter if the vehicle has remote start. The climate control system will use the previous settings during a remote start. The rear defog ...
Using the Navigation System
Use the NAV button on the faceplate or Home Page to access the navigation map. Press the NAV button again to change between alternative views of the normal split and full map views. The Menu screen button at the bottom right side of the display accesses the Navigation Menu. The touch-sens ...