Chevrolet Cruze Repair Manual: Front Suspension
Specifications
Front Suspension Components
- Drivetrain and Front Suspension Frame
- Front Stabilizer Shaft
- Drivetrain and Front Suspension Frame Rear Insulator
- Front Stabilizer Shaft Link
- Front Suspension Strut Insulator Assembly
- Front Spring
- Shock Absorber Assembly
- Front Wheel Bearing/Hub Assembly
- Front Lower Control Arm Rear Bushing
- Front Lower Control Arm
- Front Lower Control Arm Bushing
- Drivetrain and Front Suspension Frame Rear Insulator
- Stabilizer Shaft Replacement
- Stabilizer Shaft Link Replacement
- Stabilizer Shaft Insulator Replacement
- Front Wheel Bearing and Hub Replacement
- Steering Knuckle Replacement
- Lower Control Arm Replacement
- Front Lower Control Arm Bushing Replacement
- Wheel Stud Replacement
- Strut Assembly Replacement
- Shock Absorber Disposal
- Strut, Strut Component, or Spring Replacement
- Front Suspension Description and Operation
Suspension
...
Stabilizer Shaft Replacement
Special Tools
CH 904 Underframe
CH 49289 Centering Adapter
EN 45059 Torque Angle Sensor Kit
For equivalent regional tools, refer to Special Tools.
Removal Procedure
Turn the front whee ...
Other materials:
Removal Procedure
Warning: Refer to Cracked Window Warning in the Preface section.
Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section.
Note: Position the vehicle on level ground and move the front
wheels to the straight-ahead position.
Disconnect battery.
Remove quarter window ...
Lamp Messages
AUTOMATIC LIGHT CONTROL ON
This message is displayed when the automatic light control has been turned on.
AUTOMATIC LIGHT CONTROL OFF
This message is displayed when the automatic light control has been turned off.
XXX TURN INDICATOR FAILURE
When one of the turn signals is out, this message disp ...
Installation Procedure
Remove rear end upper panel extension (1) from service part.
Cut
Cut the body side inner panel in corresponding locations to fit the
remaining original panel. The sectioning joint should be trimmed to
allow a gap of one-and-one-half-times the metal thickness at the sectioni ...