Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Front Side Door Window Adjustment

Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface

Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section.

Warning: Refer to Express Window Down Warning in the Preface section.

Preliminary Procedure

  1. Remove the front side door trim. Refer to Front Side Door Trim Replacement.
  2. Remove the water deflector. Refer to Front Side Door Water Deflector Replacement.
  1. Front Side Door Window Regulator Sash Nut (Qty: 2)

Caution: Refer to Fastener Caution in the Preface section.

Tighten 10 N·m (89 lb in)

  1. Front Side Door Window

Procedure

  1. Loosen the window regulator sash nuts.
  2. Connect the door trim panel wire connector.

Note: Start the vehicle to ensure maximum power to the window motor. This is required in order to fully seat the window for adjustment.

  1. Start the vehicle.
  2. Using the power window switch, raise the window to the full up position.
  3. Tighten the front side door window regulator sash nuts.
  4. Inspect for proper window operation and a tight seal.
  5. Shut off the vehicle.
Installation Procedure
Remove all mounds or loose pieces of urethane adhesive from the pinch-weld area. Inspect for any of the following problems in order to help prevent future breakage of the window: High ...

Front Side Door Window Replacement
Preliminary Procedure Position the window approximately half   way down in the door. Remove the water deflector. Refer to Front Side Door Water Deflector Replacement. Remove t ...

Other materials:

Wipers and Washers
Specifications Wiper/Washer Schematics Windshield Wiper and Washer Switch Replacement Preliminary Procedure Remove the steering column trim covers. Refer to Steering Column Lower Trim Cover Replacement. Windshield Wiper and Washer Switch Procedure Disconnect any elect ...

Vehicle Messages
Messages displayed on the DIC indicate the status of the vehicle or some action that may be needed to correct a condition. Multiple messages may display one after the other. The messages that do not require immediate action can be acknowledged and cleared by pressing SET/CLR. The messages tha ...

Rear Spring Replacement
Removal Procedure Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle. Support the rear axle with a tall jack stand near the shock absorber. Remove the lower shock bolt. Refer to Shock Absorber Replacement. Using the tall jack stands, slowly lower the rear a ...

© 2017-2021 Copyright www.crion.site