The fore/aft manual adjuster is composed of an inboard track assembly (5), and outboard track (4) assembly, and an adjuster handle (1).
Each track assembly is made of an upper track (2) and a lower track (3). Both tracks need to be aligned prior to installing in the vehicle.
To align the front seat tracks, do the following:
Measurement for each track must be 138 mm or as close as possible.
Driver or Passenger Seat Head Restraint Replacement
Front Seat Head Restraint
Procedure
Front Seat Head Restraint Guide Replacement
Preliminary Procedure
Remove front seat head restraint. Refer to Driver or Passenger Seat Head Restraint Replacement.
Procedure
Use a flat-bladed tool to release guide for removal.
Front Seat Cushion Outer Trim Panel Replacement
Preliminary Procedure
Seat Cushion Outer Trim Panel Screw (Qty: 3)
Caution: Refer to Fastener Caution in the Preface section.
Tighten 2.5 N·m (22 lb in)
Seat Cushion Outer Trim Panel
Front Seat Cushion Inner Trim Panel Replacement
Preliminary Procedure
Driver or passenger seat replacement. Refer to Driver or Passenger Seat Replacement.
Caution: Refer to Fastener Caution in the Preface section.
Tighten 2.5 N·m (22 lb in)
Steering
Electric Power Steering
The vehicle has electric power steering. It does not have power steering fluid.
Regular maintenance is not required.
If power steering assist is lost due to a system malfunction, the vehicle can
be steered, but may require increased effort. See your dealer if there is a ...
Rear Compartment Lid Emblem/Nameplate Replacement (VCDi AT)
Rear Compartment Lid Emblem Assembly
Caution: Refer to Exterior Trim Emblem Removal Caution in the
Preface section.
Procedure
The part and surface should be 21°C (70°F) prior to installation. The
vehicle should remain 21°C (70°F) for
one hour after assembly to allow adhesive to deve ...
Installation Procedure
Create 8 x 14 mm (5/16 x 15/16 in) slots for MIG-Brazing along the edges
of the drivetrain and front suspension frame front support
as noted from the original panel.
Clean and prepare the attaching surfaces for brazing.
Position the drivetrain and front suspension frame ...