Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Front Fog Lamp Bezel Replacement

Preliminary Procedure

Preliminary Procedure

  1. Remove front bumper fascia. Refer to Front B 1. umper Fascia Replacement.
  2. Remove front fog lamp. Refer to Front Fog Lamp Replacement.
  1. Front Fog Lamp Bezel Screw

Caution: Refer to Fastener Caution in the Preface section.

Tighten 2.5 N·m (23 lb in)

  1. Front Fog Lamp Bezel

Procedure

  1. Disengage the four inner retainer tabs securing the bezel to the front bumper fascia.
  2. Pull outward from the outer edge in order to release the outer retention clips securing the bezel to the front bumper fascia.
  3. Remove the front fog lamp bezel.

Front Bumper Fascia Front Tow Eye Access Hole Cover Replacement

  1. Front Bumper Fascia Front Tow Eye Access Hole Cover

Front Side Door Window Frame Rear Cover Replacement

  1. Front Side Door Window Frame Cover Bolt (Qty: 3)

Caution: Refer to Fastener Caution in the Preface section.

Tip

Pull the window weatherstrip aside.

Tighten

2 N·m (18 lb in)

  1. Front Side Door Window Frame Cover

Rear Side Door Window Frame Front Cover Replacement

  1. Rear Side Door Window Frame Front Cover Bolt (Qty: 3)

Caution: Refer to Fastener Caution in the Preface section.

Tip

Pull the window weatherstrip aside.

Tighten 2 N·m (18 lb in)

  1. Rear Side Door Window Frame Front Cover

Radiator Grille Emblem/Nameplate Replacement (Chevrolet)

  1. Radiator Grille Emblem Screw (Qty: 2)

Caution: Refer to Fastener Caution in the Preface section.

Tighten 2.5 N·m(22 lb in)

  1. Radiator Grille Emblem Assembly
Front Fender Emblem/Nameplate Replacement (1.8L 2H0 or 2.0L Diesel)
Front Fender Emblem Assembly Caution: Refer to Exterior Trim Emblem Removal Caution in the Preface section. Procedure The part and surface should be 21°C (70°F) prior to installation. The ...

Rear Compartment Lid Emblem/Nameplate Replacement (Bowtie)
Rear Compartment Lid Emblem Assembly Caution: Refer to Exterior Trim Emblem Removal Caution in the Preface section. Procedure The part and surface should be 21°C (70°F) prior to installati ...

Other materials:

Windshield Wiper/Washer
The windshield wiper/washer lever is on the right side of the steering column. With the ignition in ACC/ ACCESSORY or ON/RUN, move the windshield wiper lever to select the wiper speed. HI: Use for fast wipes. LO: Use for slow wipes. INT: (Intermittent Wipes): Move the lever up to INT for ...

Immobilizer Operation
This vehicle has a passive theft-deterrent system. The system does not have to be manually armed or disarmed. The vehicle is automatically immobilized when the key is removed from the ignition. The system is automatically disarmed when the vehicle is started with the correct key. The key uses a ...

Interior Lamps Dimming
This group includes lamps which may dim. This group may use a combination of vacuum fluorescent illumination, LEDs and incandescent lamps HVAC control module, head assembly Rear HVAC control module, head assembly Radio Rear seat audio The instrument panel cluster The PRNDL lamp, wit ...

© 2017-2021 Copyright www.crion.site