Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Front Fender Emblem/Nameplate Replacement (1.8L 2H0 or 2.0L Diesel)

Chevrolet Cruze Repair Manual / Body hardware and trim / Exterior Trim / Front Fender Emblem/Nameplate Replacement (1.8L 2H0 or 2.0L Diesel)

Front Fender Emblem Assembly

Front Fender Emblem Assembly

Caution: Refer to Exterior Trim Emblem Removal Caution in the Preface section.

Procedure

  1. The part and surface should be 21°C (70°F) prior to installation. The vehicle should remain 21°C (70°F) for one hour after assembly to allow adhesive to develop sufficient bond strength.
  2. Use a Heat Gun or equivalent to remove the old emblem. Clean all adhesive from the front fender and wipe the surface dry with a clean lint-free towel prior to installing the new emblem.
  3. When removing protective liners from the adhesive tape, be careful not to touch tape with hands and do not allow tape to come in contact with dirt or any foreign matter prior to adhesion.
  4. Using the palm of the hand, wet out the emblem to the front fender to ensure full adhesion  of the emblem is made.
Specifications
Front Door (Diesel) 65 mm 83 mm Front Door (Diesel) 60 mm 87 mm Rear Compartment Lid (Diesel) 122 mm 32 mm Rear Compartment Lid (Ecoline) 162 mm 32 ...

Front Fog Lamp Bezel Replacement
Preliminary Procedure Remove front bumper fascia. Refer to Front B 1. umper Fascia Replacement. Remove front fog lamp. Refer to Front Fog Lamp Replacement. Front Fog Lamp Bezel Scre ...

Other materials:

Radio(s)
: Press to turn the system on and off. Turn to increase or decrease the volume. BAND: Press to choose between FM, AM, or SiriusXM®, if equipped. MENU/SEL: Turn to select radio stations. Press to select a menu. : Press to seek the previous station or track. : Press to seek the next station ...

Fuel Tank Filler Pipe Housing Replacement
Preliminary Procedure Remove rear wheelhouse panel liner. Refer to Rear Wheelhouse Panel Liner Replacement. Remove fuel tank filler door. Refer to Fuel Tank Filler Door Replacement. Fuel Tank Filler Door Lock Actuator Procedure Disconnect electrical connector. Fuel Tank ...

Installation Procedure
Create 5 x 18 mm (4/16 x 11/16 in) slots for MIG-Brazing along the edges of the front wheelhouse front panel as noted from the original panel. Create a 5 x 18 mm (4/16 x 11/16 in) slot for MIG-Brazing where front wheelhouse front panel  and front wheelhouse overlap. C ...

© 2017-2021 Copyright www.crion.site