Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Front Compartment Side Rail Sectioning (Short, MIG-Brazing)

Chevrolet Cruze Repair Manual / Body repair / Collision Repair / Front Compartment Side Rail Sectioning (Short, MIG-Brazing)

Note: According to different corrosion warranties, only the regional mandatory joining methods are allowed.

Installation Procedure
Cut the front compartment front rail in corresponding locations to fit the remaining original panel. The sectioning joint should be trimmed to allow a gap of one-and-one-half-times the met ...

Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section. Warning: Refer to Collision Sectioning Warning in the Preface section. Warning: Refer to Glass and She ...

Other materials:

Body Waterleak Repair
Warning: If the vehicle interior is exposed to moisture and becomes soaked up to the level of the sensing and diagnostic module (SDM), the SDM and SDM harness connector must be replaced. The SDM could be activated when powered, which could cause airbag deployment and result in personal inj ...

Installation Procedure
Drill 8 mm (5/16 in) for plug welding along the edges of the service panel as noted from the original panel. Clean and prepare the attaching surfaces for welding. Position the roof rear header (1) panel on the vehicle. Verify the fit of the panel. Clamp the roof rear header ...

Rear Side Door Weatherstrip Replacement - Body Side
Rear Side Door Weatherstrip - Body Side Procedure Start at the front upper corner of the door opening and pull the weatherstrip away from   the door opening flange. Position the weatherstrip in the upper corner of the center pillar. Working downward along the front edge, in ...

© 2017-2021 Copyright www.crion.site