Chevrolet Cruze Repair Manual: Front Bumper Impact Bar Replacement
Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section.
Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section.
- Disable the SIR System. Refer to SIR Disabling and Enabling.
- Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection.
- Remove all related panels and components.
- Remove the 8 front bumper impact bar bolts (1).
- Cut the front bumper impact bar left and right.
- Locate and mark all factory welds.
- Drill all factory welds.
- Remove the remaining parts of 8. the front bumper impact bar.
Installation Procedure
- Position the front bumper impact bar on the vehicle.
Caution: Refer to Fastener Caution in the Preface section.
- Install the 8 front bumper impact bar bolts (1) and tighten to 110 N·m (81 lb ft).
Note: Use only the original front bumper impact bar bolts. Replace bolts if damaged.
- Paint the repaired area. Refer to Basecoat/Clearcoat Paint Systems.
- Install all related panels and components.
- Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection.
- Enable the SIR system. Refer to SIR Disabling and Enabling.
Overlap/Backing Plate Sectioning (Welding)
Warning: Refer to Approved Equipment for Collision Repair Warning in
the Preface section.
Fit the service panel to the vehicle to ensure a proper fit.
Measure and mark a line at th ...
Headlamp Mount Panel Replacement (MAG-Welding)
Note: According to different corrosion warranties, only the
regional mandatory joining methods are allowed.
Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in t ...
Other materials:
Steering Knuckle Replacement
Preliminary Procedure
Raise and support the vehicle. Refer to Lifting and Jacking the
Vehicle
Remove the wheel bearing and hub assembly. Refer to Front Wheel Bearing
and Hub Replacement.
Separate the outer tie rod end from the knuckle. Refer to Steering
Linkage Outer Tie R ...
Collision Damage Repair
If the vehicle is involved in a collision and it is damaged, have the damage
repaired by a qualified technician using the proper equipment and quality replacement
parts. Poorly performed collision repairs diminish the vehicle resale value, and
safety performance can be compromised in subsequen ...
Installation Procedure
Prepare all mating surfaces as necessary.
Align the body lock pillar outer panel reinforcement.
Create 8 x 24 mm (5/16 x 15/16 in) slots for MIG-brazing upper (1) and
lower (2).
Clean and prepare the attaching surfaces for spot welding and brazing.
Position the body loc ...