Chevrolet Cruze Repair Manual: Frame and Underbody
Specifications
Engine Shield Replacement
Preliminary Procedure
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
- Engine Shield Bolt (Qty: 4)
Caution: Refer to Fastener Caution in the Preface section.
Tighten 40 N·m (30 lb ft)
- Engine Shield
Front Compartment Insulator Replacement
Preliminary Procedure
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
- Front Compartment Insulator Screw (Qty: 8)
Caution: Refer to Fastener Caution in the Preface section.
Tighten 3 N·m (3 lb in)
- Front Compartment Insulator Plastic Retainer (Qty: 3)
- Front Compartment Insulator
Front Compartment Splash Shield Replacement
- Front Compartment Splash Shield Retainer (Qty: 2)
- Front Compartment Splash Shield Bolt (Qty: 3)
Caution: Refer to Fastener Caution in the Preface section.
Tighten 3 N·m (27 lb in)
- Front Compartment Splash Shield
- Drivetrain and Front Suspension Frame Replacement
- Drivetrain and Front Suspension Frame Insulator Replacement
Ultra High Strength Dual Phase Steel
This information provides repair recommendations and general guidelines for
steel classified as Ultra High Strength Dual Phase Steel (Dual
Phase Steel with a tensile strength greater than 800 MPa), ...
Drivetrain and Front Suspension Frame Replacement
Special Tools
CH 904 Underframe
CH 49289 Centering Adapter
For equivalent regional tools, refer to Special Tools. ...
Other materials:
Ultrasonic Parking Assist
The Ultrasonic Rear Parking Assist (URPA) system assists the driver with parking
and avoiding objects while in R (Reverse). URPA operates at speeds less than 8 km/h
(5 mph). The sensors on the rear bumper detect objects up to 2.5m (8 ft) behind
the vehicle, and at least 20 cm (8 in) off the gr ...
Courtesy/Illuminated Entry Lamps
The following lamps may be manually turned ON by placing the interior lamp
switch in the ON position, or by opening a door while the
switch is in the AUTO position.
The dome lamp
The liftgate lamps
Courtesy lamps
The courtesy lamp supply voltage circuit of the body control module (BCM) ...
Installation Procedure
Prepare all mating surfaces as necessary.
Align the body lock pillar outer panel reinforcement.
Create 8 x 24 mm (5/16 x 15/16 in) slots for MIG-brazing upper (1) and
lower (2).
Clean and prepare the attaching surfaces for spot welding and brazing.
Position the body loc ...