Chevrolet Cruze manuals

Chevrolet Cruze Owners Manual: Exterior Lamp Controls

The exterior lamp control is to the left of the steering column on the instrument

The exterior lamp control is to the left of the steering column on the instrument panel.

There are four positions:

to turn the automatic lamp control off or on again. (Off): Briefly turn to this position to turn the automatic lamp control off or on again.

AUTO (Automatic):

Turns the headlamps on automatically at normal brightness, together with the following: • Parking Lamps
• Taillamps
• License Plate Lamps
•  Instrument Panel Lights •  Sidemarker Lamps

parking lamps on together with the following: (Parking Lamps):

Turns the parking lamps on together with the following: •  Taillamps
•  License Plate Lamps • Instrument Panel Lights •  Sidemarker Lamps

on together with the lamps listed below. A warning chime sounds if the driver door(Headlamps):

Turns the headlamps on together with the lamps listed below. A warning chime sounds if the driver door is opened when the ignition switch is off and the headlamps are on.

• Parking Lamps
• Taillamps
• License Plate Lamps
.• Instrument Panel Lights • Sidemarker Lamps

For vehicles with fog lamps, press to turn the lamps on or off.  (Front Fog Lamps):

For vehicles with fog lamps, press to turn the lamps on or off.

Exterior Lighting
...

Headlamp High/Low-Beam Changer
(Headlamp High/Low-Beam Changer): Push the turn signal lever away from you and release to turn the high beams on. To return to low beams, push the lever again or pull it toward you and release. ...

Other materials:

Front Fender Replacement
Preliminary Procedure Remove the front bumper fascia. Refer to Front  Bumper Fascia Replacement Remove front bumper fascia guide. Refer to Front Bumper Fascia Replacement Remove the wheelhouse liner. Refer to Front Wheelhouse Liner Replacement Remove the headlamp. Refer to H ...

Engine Exhaust
WARNING Engine exhaust contains carbon monoxide (CO) which cannot be seen or smelled. Exposure to CO can cause unconsciousness and even death. Exhaust may enter the vehicle if: • The vehicle idles in areas with poor ventilation (parking garages, tunnels, deep snow that may block underbody air ...

Installation Procedure
Cut the quarter outer panel in corresponding locations to fit the remaining original panel. The sectioning joint should be trimmed to allow a gap of one-and-one-half-times the metal thickness at the sectioning joint. Create a 50 mm (2 in) backing plate from the unused portion &nbs ...

© 2017-2021 Copyright www.crion.site