Chevrolet Cruze manuals

Chevrolet Cruze Owners Manual: Engine Cooling System Messages

A/C OFF DUE TO HIGH ENGINE TEMP

This message displays when the engine coolant becomes hotter than the normal operating temperature.

To avoid added strain on a hot engine, the air conditioning compressor automatically turns off.

When the coolant temperature returns to normal, the air conditioning compressor turns back on. You can continue to drive the vehicle.

If this message continues to appear, have the system repaired by your dealer as soon as possible to avoid damage to the engine.

ENGINE OVERHEATED — IDLE ENGINE

This message displays when the engine coolant temperature is too hot. Stop and allow the vehicle to idle until it cools down.

ENGINE OVERHEATED — STOP ENGINE

This message displays and a continuous chime sounds if the engine cooling system reaches unsafe temperatures for operation.

Stop and turn off the vehicle as soon as it is safe to do so to avoid severe damage. This message clears when the engine has cooled to a safe operating temperature.

HIGH COOLANT TEMPERATURE

This message displays if the coolant temperature is hot.

Door Ajar Messages
DOOR(S) OPEN A vehicle symbol will be displayed on the DIC showing which door is open along with this message. Close the door completely. HOOD OPEN This message will display when the hood is ope ...

Engine Oil Messages
CHANGE ENGINE OIL SOON This message displays when the engine oil needs to be changed. When you change the engine oil, be sure to reset the Oil Life System. OIL PRESSURE LOW — STOP ENGINE This mess ...

Other materials:

Shock Absorber Replacement
Removal Procedure Raise and suitably support the vehicle. Refer to Lifting  and Jacking the Vehicle. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation. Support the rear axle with a tall jack stand near the shock absorber. Remove the upp ...

Shock Absorber Disposal
Warning: Use the proper eye protection when drilling to prevent metal chips from causing physical injury. Clamp the strut in a vise horizontally with the rod ( 1) completely extended. Drill a hole in the strut at the center of the end cap (3) using a 5 mm (3/16 in) drill bit. Gas o ...

Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section. Warning: Refer to Collision Sectioning Warning in the Preface section. Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section. Disable the SIR System. Refer to SIR Disabling ...

© 2017-2021 Copyright www.crion.site