Chevrolet Cruze manuals

Chevrolet Cruze Owners Manual: Engine Compartment Overview

Chevrolet Cruze Owners Manual / Vehicle Care / Vehicle Checks / Engine Compartment Overview

1.4L L4 Engine

1.4L L4 Engine

 

1. Engine Air Cleaner/Filter

2. Engine Oil Dipstick.

3. Engine Cooling Fan (Out of View).

4. Engine Oil Fill Cap.

5. Remote Negative (-) Grounding Point.

6. Brake/Clutch Fluid Reservoir.

7. Battery

8. Engine Coolant Surge Tank and Pressure Cap.

9. Remote Positive (+) Terminal.

10. Engine Compartment Fuse Block

11. Windshield Washer Fluid Reservoir.

1.8L L4 Engine

1.8L L4 Engine

 

1. Engine Air Cleaner/Filter

2. Engine Oil Dipstick

3. Engine Cooling Fan (Out of View)

4. Engine Oil Fill Cap

5. Remote Negative (-) Grounding Point

6. Brake/Clutch Fluid Reservoir

7. Battery

8. Engine Coolant Surge Tank and Pressure Cap

9. Remote Positive (+) Terminal

10. Engine Compartment Fuse Block

11. Windshield Washer Fluid Reservoir

Hood
To open the hood: 1. Pull up on the hood release handle. It is located inside the vehicle to the left of the steering column. 2. Go to the front of the vehicle and push the secondary hood rele ...

Engine Oil
To ensure proper engine performance and long life, careful attention must be paid to engine oil. Following these simple, but important steps will help protect your investment: • Always use engine ...

Other materials:

Overview
Read the following pages to become familiar with the infotainment system features. WARNING Taking your eyes off the road for extended periods could cause a crash resulting in injury or death to you or others. Do not give extended attention to infotainment tasks while driving. The infotainment ...

Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section. Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section. Disable the SIR System. Refer to SIR  Disabling and Enabling. Disconnect the negative battery cable. Refer to ...

Installation Procedure
Remove rear end upper panel extension (1) from service part. Cut Cut the body side inner panel in corresponding locations to fit the remaining original panel. The sectioning joint should be trimmed to allow a gap of one-and-one-half-times the metal thickness at the sectioni ...

© 2017-2021 Copyright www.crion.site