The vehicle has fuses and circuit breakers to protect against an electrical system overload.
When the current electrical load is too heavy, the circuit breaker opens and closes, protecting the circuit until the current load returns to normal or the problem is fixed. This greatly reduces the chance of circuit overload and fire caused by electrical problems.
Fuses and circuit breakers protect power devices in the vehicle.
Replace a bad fuse with a new one of the identical size and rating.
If there is a problem on the road and a fuse needs to be replaced, the same amperage fuse can be borrowed. Choose some feature of the vehicle that is not needed to use and replace it as soon as possible.
An electrical overload may cause the lamps to go on and off, or in some cases to remain off. Have the headlamp wiring checked right away if the lamps go on and off or remain off.
If the wiper motor overheats due to heavy snow or ice, the windshield wipers will stop until the motor cools and will then restart.
Although the circuit is protected from electrical overload, overload due to heavy snow or ice may cause wiper linkage damage.
Always clear ice and heavy snow from the windshield before using the windshield wipers.
If the overload is caused by an electrical problem and not snow or ice, be sure to get it fixed.
Power Windows Description and Operation
Power Windows System Components The power window system consists of the following components: Driver window switch Passenger window switch Left rear window switch Right rear window switch Window motors in each of the doors F24UA 30A Fuse F55UA 7.5A Fuse F21UA 7.5A Fuse Body cont ...
Front Side Door Check Replacement
Prliminary Procedure Remove front side door trim panel. Refer to Front Side Door Trim Replacement Remove the front side door water deflector. Refer to Front Side Door Water Deflector Replacement Front Side Door Check Link Bolt Caution: Refer to Fastener Caution in the ...
Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section. Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section. Disable the SIR System. Refer to SIR Disabling and Enabling. Disconnect the negative battery cable. Refer to Bat ...