Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Driver or Passenger Seat Side Inflatable Restraint Module Replacement

Chevrolet Cruze Repair Manual / Restraints / Driver or Passenger Seat Side Inflatable Restraint Module Replacement

Warning: Refer to SIR Inflator Module Handling and Storage Warning

Warning: Refer to SIR Inflator Module Handling and Storage Warning in the Preface section.

Warning: Following the deployment of a side impact air bag, inspect the following parts for damage. Replace these parts if necessary:

Failure to do so may cause future personal injury.

Preliminary Procedure

Disable the SIR system. Refer to SIR Disabling and Enabling.

Front Seat Back Trim

Front Seat Side Inflatable Restraint Module Nut (Qty: 2)

Caution: Refer to Fastener Caution in the Preface section.

Tighten 4 N·m (36 lb in)

Front Seat Side Inflatable Restraint Module Assembly

Tip

Disconnect the electrical connector.

Inflatable Restraint Steering Wheel Module Coil Centering
Caution: The new SIR coil assembly will be centered. Improper alignment of the SIR coil assembly may damage the unit, causing an inflatable restraint malfunction. Verify the following condi ...

Roof Side Rail Inflatable Restraint Module Replacement
Warning: In order to prevent SIR deployment, personal injury, or unnecessary SIR system repairs, do not strike the door or the door pillar in the area of the side impact sensor (SIS). Turn OFF ...

Other materials:

Battery Voltage and Charging Messages
BATTERY SAVER ACTIVE This message displays when the vehicle has detected that the battery voltage is dropping beyond a reasonable point. The battery saver system starts reducing features of the vehicle that may be noticed. At the point that features are disabled, this message displays. Turn o ...

Steering Linkage Inner Tie Rod Replacement (Electronic Power Steering)
Special Tools CH-6247 Removal and Installation Tool for the Steering Linkage Inner Tie Rod For equivalent regional tools, refer to Special Tools. Removal Procedure Raise and support the vehicle. Refer to Lifting  and Jacking the Vehicle. Remove the tire and wheel assembly. Refer to ...

Installation Procedure
Drill 8 mm (5/16 in) for plug welding along the edges of the tail lamp pocket as noted  from the original panel. Note: Clean and prepare the attaching surfaces for welding. Position the tail lamp pocket on the vehicle. Verify the fit of the tail lamp pocket. Clamp ...

© 2017-2021 Copyright www.crion.site