Daytime Running Lamps can make it easier for others to see the front of your vehicle during the day. Fully functional daytime running lamps are required on all vehicles first sold in Canada.
A light sensor on top of the instrument panel makes the DRL work, so be sure it is not covered.
The DRL system makes the low-beam headlamps come on at a reduced brightness when the following conditions are met: • The ignition is in the ON/ RUN mode.
• The exterior lamps control is in AUTO.
• The engine is running.
When the DRL are on, only the low-beam headlamps, at a reduced level of brightness, will be on. The taillamps, sidemarker, instrument panel, and other lamps will not be on.
The headlamps automatically change from DRL to the regular headlamps depending on the darkness of the surroundings. The other lamps that come on with the headlamps will also come on.
When it is bright enough outside, the headlamps go off and the DRL come on.
To turn the DRL off or on again, turn the exterior lamp control to the off position and then release. For vehicles first sold in Canada, the DRL cannot be turned off.
Position the front end upper tie bar (1) on the vehicle. Verify the fit of the front end upper tie bar. Clamp the front end upper tie bar into position. Braze accordingly. Braze accordingly. Grind down weld seams as needed for related panels and components. Clean a ...
Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section. Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section. Disable the SIR System. Refer to SIR Disabling and Enabling. Disconnect the negative battery cable. Refer to Bat ...
Steering Knuckle Replacement
Preliminary Procedure Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle Remove the wheel bearing and hub assembly. Refer to Front Wheel Bearing and Hub Replacement. Separate the outer tie rod end from the knuckle. Refer to Steering Linkage Outer Tie R ...