Chevrolet Cruze manuals

Chevrolet Cruze Owners Manual: Danger, Warnings, and Cautions

Chevrolet Cruze Owners Manual / Introduction / Danger, Warnings, and Cautions

Warning messages found on vehicle labels and in this manual describe hazards and what to do to avoid or reduce them.

Danger indicates a hazard with a high level of risk which will result in serious injury or death.

Warning or Caution indicates a hazard that could result in injury or death.

WARNING

These mean there is something that could hurt you or other people.

Notice: This means there is something that could result in property or vehicle damage. This would not be covered by the vehicle's warranty.

A circle with a slash through it is a safety symbol which means “Do Not,” “Do

A circle with a slash through it is a safety symbol which means “Do Not,” “Do not do this,” or “Do not let this happen.”

Using this Manual
To quickly locate information about the vehicle, use the Index in the back of the manual. It is an alphabetical list of what is in the manual and the page number where it can be found. ...

Symbols
The vehicle has components and labels that use symbols instead of text. Symbols are shown along with the text describing the operation or information relating to a specific component, control, mes ...

Other materials:

Head Restraints
The vehicle's front and rear seats have adjustable head restraints in the outboard seating positions. WARNING With head restraints that are not installed and adjusted properly, there is a greater chance that occupants will suffer a neck/ spinal injury in a crash. Do not drive until the h ...

Interior Windnoise
Warning: Refer to Assistant Driving Warning in the Preface section. Interior windnoise is not heard when the window is lowered. Interior windnoise is caused by the air leaving the inside of the vehicle through a seal or a seam. Tape over the relief valves to cause added air  pressure wi ...

Installation Procedure
Clean and prepare the attaching surfaces for welding. Position the roof rear header panel (1) on the vehicle. Verify the fit of the panel. Clamp the roof rear header panel into position. Spot weld accordingly as noted   from the original panel. Apply the sealer ...

© 2017-2021 Copyright www.crion.site