Warning: A child in a rear-facing child restraint can be seriously injured if the right-front passengers air bag inflates. This is because the back of a rear-facing child restraint would be very close to the inflating air bag. NEVER use a rear-facing child restraint in this vehicle. If a forward-facing child restraint is suitable for your child, ALWAYS move the front passenger seat as far back as it will go and then install the child restraint. Be sure the child restraint position does not conflict with any additional requirements provided by the manufacturer. For more information, refer to the vehicle owners manual and the instruction that came with the child restraint.
The child seat may only be used in a forward facing seating location. The child seat should be installed and secured according to the manufacturer's directions. If the child seat has a top strap, the seat will need to be anchored. Passengers should not be allowed to sit at locations where the seat belts are being used to secure the child seat.
All vehicles are equipped with a dual-mode type retractor with emergency and automatic locking features. The automatic locking feature is for restraint of a child seat. The child seat can be secured by pulling the seat belt all the way out to lock it. Then tighten the seat belt around the child seat.
If a child seat is to be used in the second seat position, a special dealer-installed anchor must be used in order to anchor the child seat top strap. This only applies to the seats designed with the top strap provision and for the vehicles sold in Canada. In order to ensure the correct top strap angle, the child seat is only to be used at the seating position for which the top strap anchor is installed.
Fasten Safety Belt Indicators
There are 2 fasten safety belt indicators for this vehicle. The driver fasten safety belt reminder is monitored on the instrument cluster and the passenger fasten safety belt reminder is located in the PASSENGER AIR BAG ON/OFF status indicator near the center of the instrument panel. The fasten safety belt indicator may only be ON during RUN. The instrument cluster illuminates the fasten safety belt indicator under the following conditions:
The dome lamp controls are in the headliner. (Dome Lamp Override): Press to turn the lamps off, even when a door is open. (Door): Press to turn the lamps on automatically when a door is opened. (On): Press to turn on the dome lamps. ...
Align the body side outer panel reinforcement. Clean and prepare the attaching surfaces for welding. Position the body side outer panel reinforcement on the vehicle. Verify the fit of the body side outer panel reinforcement. Clamp the body side outer panel reinforcement ...
SERVICE TIRE MONITOR SYSTEM This message displays if there is a problem with the Tire Pressure Monitor System (TPMS). TIRE LEARNING ACTIVE This message displays when the system is learning new tires. TIRE PRESSURE LOW ADD AIR TO TIRE On vehicles with the Tire Pressure Monitor System (TPMS), t ...