Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Center Pillar Upper Garnish Molding Replacement

Chevrolet Cruze Repair Manual / Body hardware and trim / Interior Trim and Paneling / Center Pillar Upper Garnish Molding Replacement

Preliminary Procedure

Preliminary Procedure

  1. Remove the center pillar lower garnish molding. Refer to Center Pillar Lower Ga   rnish Molding Replacement
  2. Remove the seat belt from the front seat. Refer to Driver or Passenger Seat Retractor Side Belt Replacement
  1. Center Pillar Upper Garnish Molding Clip
  2. Center Pillar Lower Garnish Molding Assembly

Procedure

When replacing the center pillar lower garnish molding, remove the seat belt through the molding.

Center Pillar Lower Garnish Molding Replacement

Preliminary Procedure

Preliminary Procedure

  1. Remove the front side door sill trim plate. Refer to Front Side Door Sill  Trim Plate Replacement
  2. Remove the rear side door sill trim plate. Refer to Rear Side Door Sill Trim Plate Replacement.
  1. Center Pillar Lower Garnish Molding Clip (Qty: 6)
  2. Center Pillar Lower Garnish Molding Assembly

Quarter Window Garnish Molding Replacement

  1. Quarter Window Garnish Molding Assembly.
Windshield Garnish Molding Replacement
Preliminary Procedure Disable the SIR system. Refer to SIR Disabling and Enabling. Windshield Garnish Molding Assembly Procedure Loosen  tether clip and steel clips. Disconnect ...

Body Side Trim Panel Replacement - Left Side
Preliminary Procedure Remove the rear side door sill trim plate. Refer to Rear Side Door Sill  Trim Plate Replacement. Remove the rear seat back. Refer to Rear Seat Replacement. Re ...

Other materials:

Servicing the Airbag-Equipped Vehicle
Airbags affect how the vehicle should be serviced. There are parts of the airbag system in several places around the vehicle. Your dealer and the service manual have information about servicing the vehicle and the airbag system. WARNING For up to 10 seconds after the vehicle is turned off and ...

High Strength Low Alloy Steel
This information provides repair recommendations and general guidelines for steel classified as High Strength Low Alloy Steel, also known as HSLA. This type of steel normally has a tensile strength range from 300-700 MPa. General Motors recommends the following when repairing or replacing th ...

Additional Maintenance and Care
Your vehicle is an important investment and caring for it properly may help to avoid future costly repairs. To maintain vehicle performance, additional maintenance services may be required. It is recommended that your dealer perform these services — their trained dealer technicians know your v ...

© 2017-2021 Copyright www.crion.site