Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Body Lock Pillar Outer Panel Sectioning (MIG-Brazing)

Chevrolet Cruze Repair Manual / Body repair / Collision Repair / Body Lock Pillar Outer Panel Sectioning (MIG-Brazing)

Note: According to different corrosion warranties, only the regional mandatory joining methods are allowed.

Installation Procedure
Cut the body lock pillar outer panel in corresponding locations to fit the remaining original panel. The sectioning joint should be trimmed to allow a gap of one-and-one-half-times the met ...

Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section. Warning: Refer to Collision Sectioning Warning in the Preface section. Warning: Refer to Glass and She ...

Other materials:

Entry Lighting
The headlamps, parking lamps, taillamps, back-up lamps, and most of the interior lamps turn on briefly when is pressed on the Remote Keyless Entry (RKE) transmitter. After about 30 seconds the exterior lamps turn off, and then the dome and remaining interior lights will dim to off. Entry lig ...

Rear Side Door Wiring Harness Replacement
Preliminary Procedure Remove the rear side door inner panel trim. Refer to Rear Side Door Trim Replacement. Rear Side Door Wiring Harness Warning: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF befor ...

Exterior Lamp Controls
The exterior lamp control is to the left of the steering column on the instrument panel. There are four positions: (Off): Briefly turn to this position to turn the automatic lamp control off or on again. AUTO (Automatic): Turns the headlamps on automatically at normal brightness, togethe ...

© 2017-2022 Copyright www.crion.site