Chevrolet Cruze manuals

Chevrolet Cruze Owners Manual: Battery Voltage and Charging Messages

Chevrolet Cruze Owners Manual / Instruments and Controls / Vehicle Messages / Battery Voltage and Charging Messages

BATTERY SAVER ACTIVE

This message displays when the vehicle has detected that the battery voltage is dropping beyond a reasonable point. The battery saver system starts reducing features of the vehicle that may be noticed. At the point that features are disabled, this message displays. Turn off unnecessary accessories to allow the battery to recharge.

LOW BATTERY

This message is displayed when the battery voltage is low.

SERVICE BATTERY CHARGING SYSTEM

This message is displayed when there is a fault in the battery charging system. Take the vehicle to your dealer for service.

Vehicle Messages
Messages displayed on the DIC indicate the status of the vehicle or some action that may be needed to correct a condition. Multiple messages may display one after the other. The messages that do ...

Brake System Messages
BRAKE FLUID LOW This message is displayed when the brake fluid level is low. RELEASE PARKING BRAKE This message is displayed as a reminder that the parking brake is on. Release it before you atte ...

Other materials:

Front Fog Lamp Bezel Replacement
Preliminary Procedure Remove front bumper fascia. Refer to Front B 1. umper Fascia Replacement. Remove front fog lamp. Refer to Front Fog Lamp Replacement. Front Fog Lamp Bezel Screw Caution: Refer to Fastener Caution in the Preface section. Tighten 2.5 N·m (23 lb in) Fro ...

Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section. Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section. Disable the SIR System. Refer to SIR  Disabling and Enabling. Disconnect the negative battery cable. Refer to Bat ...

Installation Procedure
Drill 8 mm (5/16 in) for plug welding along the edges of the service panel as noted from the original panel. Clean and prepare the attaching surfaces for welding. Position the roof rear header (1) panel on the vehicle. Verify the fit of the panel. Clamp the roof rear header ...

© 2017-2021 Copyright www.crion.site