Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Backup Lamp Replacement

Chevrolet Cruze Repair Manual / Body systems / Lighting / Backup Lamp Replacement

Preliminary Procedures

Preliminary Procedures

  1. Remove the rear compartment sill trim plate. Refer to Rear Compartment Sill  Trim Plate Replacement.
  2. Disconnect the electrical harness connector from the backup lamp socket.
  1. Back Up Lamp Nut (Qty: 4)

Caution: Refer to Fastener Caution in the Preface section.

Tighten 5 N·m (44 lb ft)

  1. Back Up Lamp Assembly

Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section.

Warning: Refer to Halogen Bulb Warning in the Preface section.

Procedure

  1. Reach inside the rear compartment lid inner panel and remove the lower and upper retainer nuts securing the lamp assembly to the outer rear compartment lid panel.
  2. Push the inside edge of the lamp assembly outward from the rear outer compartment lid panel.
  3. Remove and transfer the bulb socket from the back up lamp assembly.

Backup Lamp Bulb Replacement

Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface

Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section.

Preliminary Procedure

Remove the rear compartment sill trim plate. Refer to Rear Compartment Sill Trim Plate Replacement.

  1. Back Up Lamp Socket

Tip

Rotate the lamp socket counterclockwise and remove from the tail lamp housing.

  1. Back Up Lamp Bulb

Warning: Refer to Halogen Bulb Warning in the Preface section.

Procedure

Remove the bulb from the lamp socket.

Fog Lamp Aiming
Preparation Procedure Important: Horizontal aim is not adjustable on this vehicle. Vertical aim is done by an adjusting nut located on the rear of the fog lamp. Prior to aiming the fog lamps, pe ...

Forward Lamp Wiring Harness Replacement
Preliminary Procedures Remove the front bumper. Refer to Front Bumper Fascia Replacement. Remove the headlamp. Refer to Headlamp Replacement. Using a scan tool, check for DTCs. Forward ...

Other materials:

Instrument Panel Assembly Replacement
Preliminary Procedures Disable the SIR system. Refer   to SIR Disabling and Enabling Remove the front floor console assembly. Refer to Front Floor Console Replacement. Remove the radio assembly. Refer to Radio Replacement. Remove the driver information display bezel. Refer ...

Test Probe Caution
Caution: Do not insert test equipment probes (DMM etc.) into any connector or fuse block terminal. The diameter of the test probes will deform most terminals. A deformed terminal will cause a poor connection, which will result in a system failure. Always use the EL-35616 GM-Approved Terminal T ...

Stationary Window Waterleak Repair
Note: If any water enters the vehicle interior up to the level of the carpet or higher and soaks the carpet, the sensing and diagnostic module (SDM) and the SDM harness connector may need to be replaced. The SDM could be activated when powered, which could cause deployment of the air bag(s) an ...

© 2017-2021 Copyright www.crion.site