Chevrolet Cruze manuals

Chevrolet Cruze Owners Manual: Automatic Headlamp System

When it is dark enough outside and the exterior lamp control is in the automatic position, the headlamps come on automatically.

The vehicle has a light sensor on top of the instrument panel. Make sure it is

The vehicle has a light sensor on top of the instrument panel. Make sure it is not covered, or the headlamps will be on when they are not needed.

The system may also turn on the headlamps when driving through a parking garage or tunnel.

Lights On with Wipers

If the windshield wipers are activated in daylight with the engine on, and the exterior lamp control is in AUTO, the headlamps, parking lamps, and other exterior lamps come on. The transition time for the lamps coming on varies based on wiper speed. When the wipers are not operating, these lamps turn off.

Move the exterior lamp control to or  to disable this feature. or Hazard Warning Flashers to disable this feature.

Daytime Running Lamps (DRL)
Daytime Running Lamps can make it easier for others to see the front of your vehicle during the day. Fully functional daytime running lamps are required on all vehicles first sold in Canada. A li ...

Hazard Warning Flashers
(Hazard Warning Flasher): Press and momentarily hold this button on the instrument panel above the climate control system, to make the front and rear turn signal lamps flash on and off. This ...

Other materials:

Windshield Garnish Molding Replacement
Preliminary Procedure Disable the SIR system. Refer to SIR Disabling and Enabling. Windshield Garnish Molding Assembly Procedure Loosen  tether clip and steel clips. Disconnect electrical connector. The tether clip at the upper portion of the garnish molding MUST be repla ...

Tire Designations
Tire Size The following is an example of a typical passenger vehicle tire size. (1) Passenger (P-Metric) Tire: The United States version of a metric tire sizing system. The letter P as the first character in the tire size means a passenger vehicle tire engineered to standards set by the U.S. ...

Rear Compartment Lid Emblem/Nameplate Replacement (VCDi AT)
Rear Compartment Lid Emblem Assembly Caution: Refer to Exterior Trim Emblem Removal Caution in the Preface section. Procedure The part and surface should be 21°C (70°F) prior to installation. The vehicle should remain 21°C (70°F) for one hour after assembly to allow adhesive to deve ...

© 2017-2021 Copyright www.crion.site