Chevrolet Cruze Repair Manual: Air Conditioning Compressor and Condenser Hose Replacement (1.6L LDE, LXV,
and 1.8L 2H0)
Removal Procedure
- Recover the refrigerant. Refer to Refrigerant Recovery and Recharging
- Remove front bumper fascia. Refer to Front Bumper Fascia Replacement

- Remove A/C compressor and condenser hose nut (1) from A/C condenser (2).

- Remove A/C compressor and condenser hose bolt (1) from A/C compressor
(2).

- Remove A/C compressor and condenser hose nut (1) from refrigerant hose
(2).
- Remove A/C compressor and condenser hose.
Installation Procedure
Note: Use NEW O-ring seals. Refer to Air Conditioning O-Ring
Seal Replacement
- Install A/C compressor and condenser hose.
Caution: Refer to Fastener Caution in the Preface section.

- Install A/C compressor and condenser hose nut (1) to refrigerant hose
(2). Tighten nut to 19 N·m (14 lb ft).

- Install A/C compressor and condenser hose bolt (1) to A/C compressor
(2). Tighten bolt to 19 N·m (14 lb ft).

- Install A/C compressor and condenser hose nut (1) to A/C condenser (2).
Tighten nut to 19 N·m (14 lb ft).
- Install front bumper fascia. Refer to Front Bumper Fascia Replacement
- Evacuate and charge the refrigerant system. Refer to Refrigerant
Recovery and Recharging
Removal Procedure
Recover the refrigerant. Refer to Refrigerant Rec overy and
Recharging.
Remove front bumper fascia. Refer to Front Bumper Fascia Replacement.
Remove A/ ...
Preliminary Procedures
Recover the refrigerant. Refer to Refrigerant Recovery and Recharging.
Remove the headlamp - right side. Refer to Headlamp Replacement.
Loosen power steering fluid r ...
Other materials:
Installation Procedure
Position the front end upper tie bar (1) on the vehicle.
Verify the fit of the front end upper tie bar.
Clamp the front end upper tie bar into position.
Weld seam accordingly.
Weld seam accordingly.
Grind down weld seams as needed for related panels and components.
...
Installation Procedure
Apply structural adhesive on the flanges of the front side door inner
panel where the front side door outer panel bears on.
Align the front side door outer panel.
Verify the fit of the front side door outer panel.
Clamp the front side door outer panel into position.
Pre-f ...
Rear Wheel Bearing and Hub Replacement (Disc Brake)
Special Tools
EN 45059 Torque Angle Sensor Kit
For equivalent regional tools, refer to Special Tools.
Removal Procedure
Raise and suitably support the vehicle. Refer to Lifting and
Jacking the Vehicle.
Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and
...