Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Additional links

Chevrolet Cruze Repair Manual / Additional links

Instrument Cluster Replacement

Preliminary Procedure

Preliminary Procedure

  1. Remove instrument panel lower cluster trim plate. Refer to Instrument Panel Cluster Lower Trim Plate Replacement.
  2. Remove instrument panel steering column upper trim cover. Refer to Steering Column Upper Trim Cover Replacement.
  1. Instrument Cluster Screw (Qty: 2)

Caution: Refer to Fastener Caution in the Preface section.

Tighten 2.5 N·m (22 lb in)

  1. Instrument Cluster Assembly

Procedure

  1. Disconnect electrical components.
  2. After repairs, refer to Control Module References

Radio Control Module Replacement

Preliminary Procedures

Preliminary Procedures

Remove instrument panel center upper molding. Refer to Instrument Panel Center Upper Molding Replacement

  1. Radio Control Module Bolts (Qty: 2)

Caution: Refer to Fastener Caution in the Preface section.

Tighten 2.5 N·m(22 lb in)

  1. Radio Control Module

Procedure

Disconnect electrical components.

Radio Replacement

Preliminary Procedure

Preliminary Procedure

  1. Disconnect the battery negative cable. Refer to Battery Disconnect Warning
  2. Remove radio control module. Refer to Radio Control Module Replacement
  1. Radio Bolts (Qty: 4)

Caution: Refer to Fastener Caution in the Preface section.

Tighten 2.5 N·m(22 lb in)

  1. Radio Bolt Washer (Qty: 4)
  2. Radio Assembly

Procedure

  1. Disconnect electrical components.
  2. After repairs, refer to Control Module References for programming and set up information.

Radiator Support Bracket Replacement

Preliminary Procedure

Preliminary Procedure

Remove the front bumper fascia. Refer to Front Bumper Fascia Replacement.

  1. Radiator Support Bracket Bolt

Caution: Refer to Fastener Caution in the Preface section.

Tighten 22 N·m (17 lb ft)

  1. Radiator Support Bracket

Procedure

Pull the radiator forward until the bracket is reachable.

Heating and Air Conditioning System Description and Operation
Engine Coolant Engine coolant is the key element of the heating system. The thermostat controls engine operating coolant temperature. The thermostat also creates a restriction for the cooling syst ...

Battery Negative Cable Disconnection and Reconnection
Removal Procedure Turn on the radio and record all of the customer radio station presets. Ensure that all lamps and accessories are turned off. Turn the ignition OFF and remove the ignition ke ...

Other materials:

Rear Bumper Fascia Outer Guide Replacement
Preliminary Procedure Remove the rear bumper fascia. Refer to Rear Bumper Fascia Replacement. Rear Bumper Fascia Outer Guide Rivet (Qty: 3) Special Tools BO-594-A Hand Rivet Tongs For equivalent regional tools, refer to Special Tools. Rear Bumper Fascia Outer Guide ...

Jump Starting
If the battery has run down, try to use another vehicle and some jumper cables to start your vehicle. Be sure to use the following steps to do it safely. WARNING   Batteries can hurt you. They can be dangerous because: • They contain acid that can burn you. • They contain gas ...

Floor Carpet Drying
If the carpet or the pad or insulator is wet, use the following criteria for drying or for replacing the components: For a 1-piece carpet assembly bonded to a cotton or a fiber padding, replace the entire assembly For a 2-piece carpet assembly with a cotton or a fiber padding, replace ...

© 2017-2021 Copyright www.crion.site